With 156 high-quality LEDS, the LED strip can output two different colors of light, Cool white and yellow, which can be used as a DRL and turn signal light. When the car is driving normally, the Cool white light is on. When the car is turning, the Cool white light will turn into yellow light. Made of soft rubber, it has strong flexibility and can be bent to any shape. The special design allows you to freely DIY cropping to achieve the effect you want. Installation is very simple, just tear off the paper on the back of the light strip and stick it where you want to install it. The tape has strong adhesion and can be sticked on most surfaces. Note: When installing as a turn signal, it must be installed in the correct direction. Be sure to place the correct LED strip on each side of the car. WHITE & AMBER The white light can be used as a DRL, while the yellow light can be used as a turn signal light. The light kit with high brightness, even in the daytime looks very bright. DIY INSTALLATION It can be cut every 3 LEDs for different lengths according to different installation positions. Note: The cut strips need to be sealed with insulating glue for waterproof protection. WIRING DIAGRAM Yellow wire connect to turn signal (+) Red wire connect to headlight or ACC (+) Black wire connect to battery negative (-)